No action/No led is present on the STB’s front panel after power up


1. Unplug the power cable for 30 seconds and plug it in.

2. Make sure the power supply is plugged to an active wall outlet and the outlet is an active one.

3. Verify if the LED on the power supplier is on.

4. Check if all cables are properly connected and that the receiver is switched on

The standby indicator on the front panel is red, isn’t receiving signals from my remote control or it is receiving but no action


1. Press the OPERATE button on the RCU.

2. Make sure the RCU is active.

3. if the LED is blinking when the remote is in use try to: Remove batteries, Press repeatedly the buttons, Leave the remote control for a couple of minutes, Insert the batteries

4. Turn the STB off and on.

5. Unplug the power cable for 30 seconds and plug it in.

6. Follow the instructions above for frozen channels.